An R17 listing does not describe all wheel dimensions. Width, bolt pattern, offset, centre bore, load rating and clearances also matter.
Illustrated teaching diagram
Diameter and width, inches
Bolt pattern and PCD, mm
Offset and centre bore, mm
Checks, step by step
Photograph the old wheel's markings and record the complete specification. Diameter and width commonly use inches; ET and DIA use millimetres. PCD describes hole count and bolt-circle diameter.
Relevant category: Wheel rims →
Check vehicle and wheel requirements. Matching PCD does not establish brake or suspension clearance. A casual claim that a few millimetres do not matter is not an approved tolerance.
Relevant category: Cast alloy rims →
Agree fasteners, tyres and pressure sensors separately. Have a workshop check installation against documentation before use. Send vehicle, current specification and desired size for a specific proposal.
Relevant category: Steel rims →
Sources and scope
Checked 8 October 2026. This guide explains general selection steps. It confirms neither stock, fitment nor services for a specific item. Use your own vehicle documentation for requirements.